Residential service
House rewiring in Charlotte, NC
House rewiring replaces old or unsafe wiring with new copper circuits, grounded outlets, and modern breaker protection. Lightning Power Electric rewires Charlotte homes with knob-and-tube, cloth-insulated, and aluminum wiring, and wires kitchens, baths, and additions during remodels. Work is staged so you keep power in part of the house, then permitted and inspected.
What’s included
Charlotte's older neighborhoods are full of houses that have been added to three or four times. We map what is actually in the walls, replace what is unsafe, and leave a panel schedule the next electrician can read.
- Whole-house rewires, staged room by room
- Knob-and-tube and cloth-insulated wiring replacement
- Aluminum branch-circuit remediation
- Kitchen, bath, and addition wiring for remodels
- Grounded outlets, GFCI and AFCI protection, new panel when needed
Signs you need it
- Two-prong outlets, or three-prong outlets that test ungrounded
- Knob-and-tube or cloth-covered wire visible in the attic or crawlspace
- Aluminum branch wiring in a house built from the mid-1960s to the early 1970s
- An insurer or home inspector flagged the wiring
- A remodel is opening walls anyway
How the job goes
- 1
Walk-through and circuit map
We trace what is there: which circuits are original, which were added, and what shares a neutral it should not.
- 2
Staging plan
The work is sequenced so part of the house stays powered. Kitchens and bathrooms get scheduled around how you live.
- 3
Rough-in and inspection
New cable is fished through attic and crawlspace with small access holes where needed. The county inspects the rough-in before anything is closed.
- 4
Devices, panel, final
New outlets, switches, and breakers go in, the panel is labeled, and the final inspection closes the permit.
What it costs in Charlotte
We bill hourly, billed in 15-minute increments, plus parts. No flat-rate menu, because no two buildings are wired alike. You get a realistic time estimate before we start and an itemized invoice when we finish.
What moves the price
- House size and number of circuits
- Access: attic and crawlspace runs are faster than finished plaster walls
- Whether the panel and service are replaced at the same time
- How much patching the walls and ceilings will need afterward
Text German a photo and a short description for a time estimate.
Permits and inspection in Mecklenburg County
Permit needed: Yes, permitted and inspected
Rewiring needs an electrical permit from Mecklenburg County Code Enforcement, with a rough-in inspection before walls are closed and a final inspection at the end. We apply for the permit and schedule both. North Carolina currently enforces the 2020 National Electrical Code with state amendments.
Common questions
Mostly. In a single-story house with attic and crawlspace access, new cable can be fished to most locations through small holes. Plaster walls, two-story houses, and finished basements need more access openings. We tell you where before we start.
Age alone does not decide it. The wiring type does. Knob-and-tube from before the 1940s, cloth-insulated cable, and aluminum branch circuits from the mid-1960s to early 1970s are the usual reasons. A 1990s house with copper wiring rarely needs a rewire.
It depends on size and access. As a reference, our whole-house rewire of a 1924 NoDa bungalow, including a 60-amp to 200-amp service upgrade, took nine days.
Square footage, the number of circuits, wall type, and whether the panel is replaced set the price. We bill hourly plus parts and give you a staged time estimate after the walk-through, so you can see where the hours go.
Often, yes. Aluminum branch circuits can be made safe by re-terminating every connection with connectors listed for aluminum-to-copper splices. It costs less than a rewire and is a recognized repair. We will tell you which approach fits your house.
One text. One conversation. One bill.
Got something electrical that’s bugging you?
Skip the form, skip the call center. Text German directly. He reads every message and most of the time he’s the one who shows up.
Or use the contact form